Supplies Shrink Tubes
Shrink Tube Description:
The DuraLabel PRO 300 prints polyolefin shrink tubes for labeling wires.
Shrink tubes are slipped over the end of a wire and then heat shrunk to a tight fit. As shown to the left, they can even be shrunk over the connector on the end of a wire.
Shrink tubes provide a permanent label on the wire. Once shrunk onto the wire they will not come off unless cut.
DuraLabel PRO Shrink Tube will print flat because the tube needs to be slipped over the end of the wire, shrink tubes can not be applied after a wire has been terminated.
How It Works:
Shink tube material is supplied flat on 25 foot rolls. When flat the shrink tube will be approximated 1.5 times as wide as its open diameter. It is printed flat and then opened up to slip it onto the wire.
Once the shrink tube label is in place, a heat gun is used to shrink the label to a tight fit on the wire.
Specifications:
| Part Number | Open Diameter | Minimum Expanded I.D. | Maximum Recovered I.D. | Recovered Wall Thickness | |||
| inches | mm | inches | mm | inches | mm | ||
| 70215 | 1/8" | 0.125 | 3.18 | 0.042 | 1.06 | 0.023 +/- 0.003 | 0.58 +/- |
| 701875 | 3/16" | 0.188 | 4.76 | 0.063 | 1.60 | 0.08 | |
| 7025 | 1/4" | 0.250 | 6.35 | 0.083 | 2.12 | 0.023 +/- 0.003 | 0.58 +/- |
| 70375 | 3/8" | 0.375 | 9.53 | 0.125 | 3.18 | 0.08 | |
| 7050 | 1/2" | 0.500 | 12.70 | 0.166 | 4.23 | 0.023 +/- 0.003 | 0.58 +/- |
| 7075 | 3/4" | 0.750 | 19.05 | 0.250 | 6.35 | 0.08 | |
| 7100 | 1" | 1.000 | 25.40 | 0.333 | 8.47 | 0.024 +/- 0.003 | 0.61 +/- |
| 0.08 | |||||||
| 0.024 +/- 0.003 | 0.61 +/- | ||||||
| 0.08 | |||||||
| 0.024 +/- 0.003 | 0.61 +/- | ||||||
| 0.08 | |||||||
Do you need to label larger cables, or wires that are already terminated?
Use DuraLabel PRO self-laminating wirewraps.
Give us a call today for more information about wire and cable labeling, or to place an order for your DuraLabel PRO 300.
